Experimental dense single screw extrusion and pelletizing machine features:
Takes up less space, easy to operate and low maintenance.
Generally used for: laboratory development of scientific research in factories. School teaching and so on.
Such as: Shanghai University, Zhengzhou University, Wenzhou...
Using a specific shaped screw, rotating in a heated barrel, the plastic fed from the hopper is squeezed forward to plasticise (i.e. melt) the plastic evenly, and through the head and different shaped moulds, the plastic is squeezed into continuous layers of the various shapes required to extrude and...
High speed single screw plastic pelletizing line:
This line is mainly used for extruding soft and hard polyethylene, polyethylene and other thermoplastics. It can be used with the corresponding auxiliary machines (including the forming head) to add a variety of plastic products, such as film t...
Features of the compacting and granulating unit:
1. Fully automatic temperature and time control system is adopted for the compacting machine, which makes the operation precise and easy, and the mixing and tempering can achieve the best dispersing and uniform effect.
2. The feeding device adopts AC...
1. High output and low energy consumption.
2. Each gear in the hardened gearbox is heat-treated and finely ground, with an internal forced cooling system to ensure high efficiency, low noise and long service life.
3. Screw geometry parameters, reasonable design, for different raw materials, to do di...
Twin-screw extruder barrel
1. Barrel: length L=190mm/section, 11 sections of barrel, material 45 steel with alloy sleeve, the barrel is water cooled.
2. The first barrel is the feeding barrel, the tenth barrel is the vacuum barrel, the eleventh barrel is the extrusion barrel.
3. The rest of the barr...
Wire drawing machine Advantages of 3D printer consumables equipment:
1. The whole set of equipment is reasonably designed and ergonomic, only one person can complete the operation.
2. The screw and barrel of the extruder are treated with advanced 38CrMoALA nitriding, with long service life and good...
1. When the head pressure exceeds the set alarm value, the material pressure alarm light will be on and the machine will stop automatically.
2. The main motor and the oil pump motor have electrical interlock, that is, if the oil pump motor does not start, the main motor cannot start; if the main mot...
1. Twin-screw extruder with high-precision barrel and modular combination, lateral foliation, easy to change colour.
2. Segmented barrels with high efficiency heat exchange automatic control system, no solidification.
3. Screw elements can be freely combined according to technical requirements.
4. T...
1. Clean the machine frequently to keep it clean inside and outside.
2. When servicing the machine, ensure that the machine is at a standstill, the power and air supply is switched off and a warning sign is hung to prevent the machine from running suddenly and causing a safety accident.
3. When serv...
Start-up procedure and precautions for water-drawn pelletizing units
(1) Thoroughly clean the equipment can be cleaned of miscellaneous materials.
(2) Check the water level of the drawbar tank, the water level of the soft water tank and the water source are normal.
(3) Open the electric cabinet and...
Main features of the dense conical twin-screw extrusion and pelletizing machine:
（1）Compacting machines
For homogeneous mixing of materials.
（2）Cone double feeder
The variable diameter, variable torque convergent structure enhances the material extrusion capacity, while the flat nozzle hea...
IPv6 network supported
